CENTERING DEVICE, RBK-X1
Rev. 1
Jan. 2021
.
Page 11
iii.
Connect the Socket (extension cable) with Plug (Detection Unit) like below capture, then fix the
connector in suitable place by tie-wraps and fix base,
and make sure the cable won’t affect the
movement of machine. Location refer to below capture.
Plug (Detection Unit)
Socket (connection cable)
4. Adjust on Detection Unit.
Allow the detection arm fall to vertical, then insert a cable into heating chamber, checking the cable
can 100% contact with detection plate successfully. If not, adjust the set screw, to adjust the swing
angle of detection arm.
5. Install the cover, by the M4 screw with plastic gasket.
Set screw
Detection plate
Detection arm
