408-10231
5
of 5
Rev
D
Figure 4
ITEM TO BE INSPECTED
INSPECTION/PROBLEM
POSSIBLE SOLUTION
“C”-Head
Inspect for cracks, gouges, nicks, or galling
on the “C”-Head or where the “C”-Head
contacts dies.
Return tool for repair (see Section 6,
RETURN/REPAIR).
Check to see if the upper die retaining pin
does not hold the stationary die in place.
Return tool for repair (see Section 6,
RETURN/REPAIR).
Cylinder
Inspect for evidence of cracks, gouges,
nicks, or galling.
If there are cracks, return the tool for repair
(see Section 6, RETURN/REPAIR).
For traces of gouges, nicks, or galling:
Remove any sharp edges using a fine
emery cloth.
Ram
Inspect the ram in the Power “ON” (ram
advanced) position for evidence of galling,
cracks, or oil leaks between the ram and the
cylinder.
If there are cracks or leaks, return the tool
for repair (see Section 6, RETURN/
REPAIR).
Check to see if the moving die retaining ball
does not hold the moving die in place.
Return tool for repair (see Section 6,
RETURN/REPAIR).
Inspect the ram in the Power “OFF” (ram
retracted) position to ensure that the ram
returns freely to its original position.
Return tool for repair (see Section 6,
RETURN/REPAIRS).
