Page 9
MICROgarde controller I and II
04.20.11.18
2
Installation
What’s in the box
Without PSU:
1 x MICROgarde controller (with or without IP module depending on order)
1x Polythene bag containing: 3 x screws, 3 x raw plugs, 1 x tamper spring, 2 x ceramic
capacitors for mains filter, 2 x diode suppressors and
1x Quick Install guide
With PSU:
1 x MICROgarde controller (with or without IP module depending on order)
1 x Mains PSU with separate fuse board
1x Polythene bag containing: 4 x screws, 4 x raw plugs, 1 x tamper spring, 2 x diode
suppressors and
1 x Polythene bag containing: 4 x ABS mounting pillars
1x Quick Install guide
WARNING!
Lock strike suppression devices (2 DIODE SUPPRESSORS ARE SUPPLIED)
MUST be fitted directly across all inductive loads such as lock strikes, secondary relays and
automatic door openers. Failure to adhere to this notice will invalidate the warranty of this product
and may result in irreparable damage to it and other connected equipment.
Physical Installation
The MICROgarde controller is designed to be mounted on flat (or nearly-flat) surfaces while
allowing cables to pass underneath. Four screws and mounting pillars are required to mount
the chassis onto the wall.
The acceptable temperature range for the controller is -5°C to +50°C. The controller
generates some heat and the ambient temperature where the controller is installed may rise
without adequate ventilation.
WARNING!
When installing the lid on a MICROgarde with PSU ensure the lip of the lower case
is visible, preventing the lid from lifting: