TDS TSC 2000 series, User Manual

Page: 7 / 58

TM Module Users Manual
Tops Digital Solutions TM Module Users Manual Ver.1.0 4
Support
If you encounter any problems after reading this manual, contact your Tops Digital Security Tech Support
representative. You can also browse the Technical Support site, located in the Support section of our website,
for solutions to many of the most common problems.
Tops Digital Security technical support personnel is available for help with all Tops hardware and software
products.
To reach technical support
On the Web: Click Support tab on www.topsds.com
By phone: (909) 203-9470 Monday to Friday, from 9 AM to 5:30 PM PST
Safety Warnings and Information
Electrical shock hazard
• Never attempt to connect the unit to any power source other than the type for which it was intended.
• Use only the power supply provided.
• Never open the casing!
• If a fault occurs, disconnect the power supply unit from the mains supply and from all other devices.
• Install the unit and power it on only in dry, weather-protected areas.
• If safe operation of the unit cannot be guaranteed, remove it from service. This might happen if:
– there is visible damage to the unit or power cables
– the unit no longer works properly
– the unit has been exposed to rain or moisture
– foreign matter has infiltrated the unit
– the unit has been stored in improper conditions
– the unit has been exposed to a high level of stress during transport
In such cases, contact DVTel Technical Support.
Installation and operation
• Always comply with relevant electrical guidelines.
• Before installing or operating the unit, make sure you have read and understood the documentation for all
other equipment connected to it (e.g. cameras, analog monitors, etc.).
• Follow the installation and operating procedures described in this manual. Failure to do so may result in
personal injuries, property damage or damage to the equipment.
Maintenance and repair
• Never open the casing of the 7700 Series unit. It does not contain parts that you can repair or replace.
• Never open the housing of the power supply unit. The power supply unit does not contain parts that you can
repair or replace.
• Ensure that all maintenance or repair work is performed exclusively by qualified personnel (electrical
technicians).