20
BA-PZ3_ML / F0354400
8
Taking out of service
•
Press the start/stop button again to stop plasma generation.
•
Disconnect the power supply once work is completed.
9
Maintenance
9.1
Cleaning
•
Clean the plasma generator only on the outside.
•
Make sure that the plasma generator is disconnected from the power supply.
•
Clean the plasma generator only with a cloth moistened with water. Do not use
solvents to clean the plasma generator!
•
Do not clean the piezo element.
9.2
Replacing a module
The modules can be subject to wear depending on the application and should be
exchanged for consistent treatment results. Proceed as described in section 7.1.
You can obtain replacement modules directly from relyon plasma. To optimize our modules,
we evaluate returned modules. Please contact us and send us back your defective or
replaced modules for analysis.
Attention
–
Damage to device!
Never touch the piezo element at the front end of the device with sharp objects. This
component can be damaged by improper handling.
(ES) Equipements Scientifiques SA - Département Composants & Modules - 127 rue de Buzenval BP 26 - 92380 Garches
Tél. 01 47 95 99 84 - Fax. 01 47 01 16 22 - e-mail: [email protected] - Site Web: www.es-france.com
