TDK-Lambda Genesys GEN10-240, User Manual

Page: 40 / 82

1
2
3
4
5
6
7
Sec. 5.7, 5.10
Sec. 6.2, 5.9,
6.6
IF_COM
+5V +5V+/-5% MAX CURRENT 0.2A
+15V+/-5% MAX CURRENT 0.2A
Isolated Interface Common Return for the SO, ENA
control, PS_OK signal and for the RS232/485 optional
IEEE interface.
NC
NC
+15
NC
COM
Control Common. Return for VMON, IMON, CV/CC,
LOC/REM. Referenced internally to the negative output
potential.
Terminal Signal name
Function
Reference
The COM terminal (Pin 7) is referenced internally to the -V
potential (and J1 Pin 12) of the power supply. Do not
attempt to bias any of these terminals relative to the -V or
any other potential. Use the Isolated Programming
interface option to allow control from a programming
source at a different potential .
31
Table 4-2: Rear panel connections and controls
RJ-45 type connector, used for chaining power supplies to form
a serial communication bus.
Connector for remote analog interface. Includes output voltage and
current limit programming and monitoring signals, Shut-off control
(electrical signal), Enable/Disable control (dry-contact), power
supply ok (PS_OK) signal and operation mode (CV/CC) signal.
Nine position DIP switch for selecting remote programming and
monitoring modes for Output Voltage, Current Limit and other
control functions.
Blank sub-plate for standard units (shown). Isolated Remote
Analog programming connector for units equipped with
Isolated Analog control option. IEEE connector for units
equipped with IEEE programming option.
M4 stud and hardware for chassis ground connection.
Number
Item Description Section
4.5
4.3.1
Connector for making remote sensing connections to the load
for regulation of the load voltage and compensation of load
wire drop.
4.4
4.4.1
4.4.2
3.8.2
3.10.2
3.10.3
4
5
6
7
8
10
9
Remote Out
connector
Programming
and
Monitoring
connector
SW1 Setup
switch
Remote
sense
connector
Blank
Sub-plate
Ground stud
Auxiliary
Auxiliary Power Supply
7.3
7.4
1
2 3 4 5 6 7
+5V
IF_COM +15V
COM
Same ground
as P/S negative
output
Isolated from
PS outputs,
same ground
as RS232/485
4.3.1 Auxiliary Power Supply
There are two Auxiliary outputs provided:
+5V Output Max output current is 0.2A
+15V Output Max output current is 0.2A
The Auxiliary output voltage considered as limited power source.
4.3.1.1 Connector detail:
4.3.1.2 Connector functions description:
CAUTION
VORSICHT
Der COM-Anschluss (Pin 7) ist intern mit dem "-V" -Potential
des Netzteils (und dem Pin 12 von J1) verbunden. Versuchen
Sie nicht, zwischen einem dieser Anschl
I I
I
üsse und -V oder
einem anderen Potential eine Spannung aufzubauen.
Verwenden Sie die Option " solated Programming nterface "
( solierte Programmierschnittstelle), wenn Sie das Netzteil von
einem Gerät mit einem anderen Potential aus steuern wollen.
31