TDC UTV Quad, Owner'S Manual

Page: 12 / 22

12
16
4
5
19
21
Front bottom view
Φ
Front inside view
Front bottom view
t u n k c o l e h t d n a r e h s a w c it s a l p 2 1 e h t e v o m e R
Fig. 3
Fig. 4
Fig. 5
Attach the Front Axle
Turn the vehicle body upside down.
1
.Remove the Lock Nut (5) and Ø12 Washer (4) on the Front Axle (16) . Fit the Front
Axle (16) to the front of the Vehicle Body (1)
2 . Insert the bent end of the
Steering Column
into the hole on the
Front Axle Linkage
.
Fit a
Ø10 Plastic Washer (19)
to the bent end of the
Steering Column
and insert a
Split Pin (21)
into the hole on the
Steering Column
, bend the ends of
Split Pin (21)
back using
Long Nose Pliers (not
included)
. (Fig. 3)
3.
Remove the Screws , Ø8 Plastic
Washers (x2) and the Nuts from the
Front Shock Absorbers with two Hex
Wrenches . Line up the holes on the
Front Axle Frame with the holes on the
Front Shock Absorber , and reinsert
the Screw , Ø8 Plastic Washers (x2)
and fasten the Nut on the opposite
side.
(Fig. 4)
4. Repeat for the other side. (Fig. 4)
Turn Vehicle Body (1) over.
5.
Press the button located at the front
of hood and lift up the hood. Slide a
Ø12 Washer (4) and tighten a Lock
Nut (5) with a Spanner (18) .
(Fig. 5)
HINT: You may tighten the nuts on the shock absorber to adjust the
tightness of the shock absorbers.