04/2013
13
TCS TürControlSysteme AG, TCS Hotline Germany: +49 (0) 41 94/ 9 88 11 88
Subject to technical changes.
FAX: +49 (0) 41 94/ 9 88 129
Mail: [email protected]
PI_FBO1200-uk 1A
Command
Parameter
End of
com-
mand
Function
Factory set-
ting of the
parameters
Sensor AS-Adresse (10 ... 63)
3
3 X
X
*
Enter the AS address to the sensor in case for a voice connec-
tion
6
4
no voice connection
3
4
no parameter!
Starts the transmission of the TK-Interface internal parameter
block
none
Dialing register
3
5 X
X
*
Start of the read-out of the parameter block to the dialing regis-
ter XX
none
Project number (0000 ... 9999)
3
6 X
X
X
X
*
Enter the project number with 4 digits
0
0
0
0
0=OFF 1=ON
3
7 X
*
Control of the error tone output
1
0= ignore 1= door call 2= floor call
3
8 X
*
Setting the function of an internal call to the TK-Interface
2
0=no PIN 1=input-PIN
2=HW-Reset
3
9 X
*
Activate the function of an input PIN
0
0=short 1=long
4
0 X
*
Set the timeout after the dial
short = 10 s / long = 45 s
1
0=16bit, short 1=32 bit, long
4
1 X
*
Set the door release command
0
0=short
1…9 (* 30s = 30…270 s)
4
2 X
*
Not available
acknowledgement: invalid entry
0
0=commands 1=directly to AS(2)
4
3 X
*
Set the reaction on the call at the TK-Interface
0
0=normal 1=blank
4
4 X
*
Blank / not change the dial tones
0
0=no acoustic note 1=note
4
5 X
*
Acoustic note
“call at the TK-Interface“ in case of an incoming
call
1
0=4 dialing reg. 1=16 dialing reg.
2=32 dialing reg. 3=64 dialing reg.
4
6 X
*
Number of dialing register / set the type of the TK-Interface
1
0=deactivate the numeric code
1=activate the numeric code
4
7 X
*
Not available
acknowledgement: invalid entry
0
0=no numeric code SN
1=numeric code, train the SN
4
8 X
*
Not available
acknowledgement: invalid entry
0
0=max. 20 Ohm 1=max. 60 Ohm 1)
4
9 X
*
The max. permitted loop resistance between TK-Interface and
power supply and control unit
(1 not possible with BVS20)
0
