14
Programming the bell buttons
Basic principle
All devices at the TCS:BUS have an unique serial number.
The serial number of the indoor station is allocated to the bell button of the front door station. The alloca-
tion is stored in the EEPROM of the front door station.
Requirements for the programming:
►
Ensure that the access to the indoor station in the flat is granted.
►
Check if the indoor station is connected to the TCS:BUS.
►
Switch on the mains voltage. The operating LED at the power supply and control unit is on.
►
Check if a programming lock is set.
Manual TCSK
.
If the programming lock is activated, you cannot program any bell button.
To deactivate the programming lock you need a Service Device TCSK or the configuration
software configo™.
1
Power supply and control unit: switch on the programming mode of the system
Shortly press
a)
the
RUN/PROG button.
The LED blinks.
The programming mode of the system is
switched ON.
2
Deleting bell buttons
b)
Press the button which should be deleted for 6 seconds
until an acknowledgement tone sounds.
c)
Release the bell button.
Repeat step 2 to delete
further bell buttons.
3
Programming via voice communication
Establish a voice
communication to the
front door station.
d)
Press the bell
button which
should be pro-
grammed.
A ring tone sounds at the front door and indoor
station.
c)
Terminate the voice
communication.
