11
Labelling the bell button
Labelling templates as WORD files are available for
download at www.tcsag.de .
►
Enter the required names into the labelling template.
►
Print the nameplates on the special foil by using a laser
printer.
►
Alternatively label the special foil with a waterproof marker.
►
Cut out the nameplate along the marking (W x H 31 x 12
mm).
►
Remove the cap of the bell button with the special wrench
(1)
.
►
Place the nameplate back-to-front in the cap. (Fig. 9).
►
Snap-in the cap on the bell button with light pressure.
Condensation water can form inside the bell button.
Do not use nameplates made of paper.
We recommend to print out the nameplates on a
durable special foil made of plastics.
You can order replacement foils directly under E-
Mail: [email protected] or use our labelling service:
www.tcsag.de.
Fig. 8: Open the bell button
Fig. 9: Placing the nameplate
Connecting the lines
Connecting lines
Permissible cross-section:
– single-wire and fine-wire 0,2 … 0,75 mm
2
Connect further wires by using auxiliary terminals.
Use only connecting lines made of the same material and with the same diameter within one
terminal contact.
General information
Use the small slot screwdriver (enclosed in the delivery) to connect lines. Avoid damaging
the device.
Ensure that no lines are clamped on the backside of the front door station or between the
upper part of the housing and the rear panel.
