3)
Warning: Before using the heater, make sure
it’s mounted tightly on the wall.
LOCATION OF INSTALLATION
This product can be installed in a bathroom but only in the area designated by the IP rating
– Zone 3 –
see location information below.
SAFETY INSTRUCTIONS
(to be read before operating the heater).
Before using set the power-level switch which is located at the back of the heater to
“ ”. Please note: there may be a trace of odour during the first few minutes of initial
use, or after a period of storage. This is normal and will quickly disappear.
CAUTION:
Some parts of this product can become very hot and cause burns. Particular
attention has to be given where children and vulnerable people are present. Children 3
years and younger should be continually supervised when in close proximity to the heater.
Children aged from 3 to 8 years shall only switch on/off the appliance provided that it has
been placed or installed in its intended normal operating position and they have been given
supervision or instruction concerning use of the appliance in a safe way and understand the
hazards involved. Children aged from 3 to 8 year shall not plug in, regulate and clean the
appliance or perform user maintenance.
Keep the power cord away from the hot body of the heater.
Indoor use only.
Do not use the heater in areas where flammable liquids are stored or where
flammablefumes may be present.
Do not use this heater if it has been dropped;
Do not use if there are visible signs of damage to the heater;
Do not leave the heater switched on when your property is vacant.
Suitable for indoor only. This product is rated as IP24. If the product is to be installed within a bathroom
it can only be located within zone 3.
Zone 0
The area inside a bath or inside the shower
This area requires low voltage and an IP67
rating.
Zone 1
The area above the bath to a height of basin.
2.25m (7’ 4””) from the floor. If the light is
240V then a 30ma residual current device
(RCD) must also be used to protect the circuit
in this zone.
Zone 2
Zone 3
An area stretching 0.6m (1’ 11””) outside the perimeter
of the bath and to a height of 2.25m (7’ 4””) from the
floor. In addition, it is good practice to consider the area
around a wash basin, within a 60cm (1’ 11””) radius of
any tap to be considered as zone 2
Anywhere outside Zones 0, 1, and 2 and where no
water jet is likely to be used. If there is a likelihood of
water jets being used for cleaning purposes in zones 1,
2 and 3 a fitting rated a minimum of IP65 must be
used.