viii
Cable TV installer notice of proper grounding
This reminder is provided to call your attention to Article 820-40 of the National Electrical Code (Section 54 of the Canadian Electrical Code, Part
1) which provides guidelines for proper grounding and, in particular, specifies that the cable ground should be connected to the grounding
system of the building as close to the point of cable entry as practical.
Installation location
Important: This television is a table model and is designed to sit on a firm, flat surface. Don’t place the TV on soft carpeting or similar surface
because the ventilation slots on the bottom of the unit will be blocked, resulting in reduced lifetime from overheating. To assure adequate
ventilation for this product, maintain a spacing of 4 inches from the top and side of the TV receiver and 2 inches from the rear of the TV receiver
and other surfaces.
Also, make sure the stand or base you use is of adequate size and strength to prevent the TV from being accidentally tipped over, pushed off, or
pulled off the stand. This could cause personal injury and/or damage to the TV. Refer to the Important Safety Instructions on the following
pages.
Low power standby mode
The Power button (indicated by the power symbol) on this TV and its remote control puts the TV into a very low power standby mode but does
not completely turn the power off. To completely shut the power off, you must disconnect the power cord from the power outlet. The main
plug/appliance coupler is used as a disconnect device. Therefore, you should be sure that the TV is installed in a manner to enable the power
cord to be disconnected when necessary.
Note:
In situations where the power plug or appliance coupler is used as the disconnect device, the disconnect device shall remain readily
accessible and operable.
Summary of Contents for Roku 55R625
Page 10: ......
