background image

Introduction

4

Chapter 1

Precautions

Product

Read all of the instructions before operating the set. 
Keep these instructions well for future use.

Do not block or cover the ventilation openings on the 
back cover. 

Do not push objects of any kind into this unit through 
the cabinet slots as they could touch the current 
carrying parts or short-circuit parts, resulting in fire, 
electric shock, or damage to the unit.

as this may cause 

damage

Do not touch the screen surface with fingers as this 
may scratch or mar the TV screen.

Do not impact the TV screen with hard pressure as 
this may damage the TV screen severely.

Do not attempt to open the cabinet 

. There are no parts inside you can service by 

yourself. Refer all servicing to qualified personnel.

Cleaning

Dust the set by wiping the screen and the cabinet with 
a soft, clean cloth or some special liquid cleaner.

Do not apply excessive force to the screen when 
cleaning.

Do not use water or other chemical cleaner to clean the 
screen as this may damage the surface of the TV 
screen.

Unplug the set under the following conditions:

- If the set will not be used for a long period of time.

- If the power cord or the power outlet/plug is damaged.

- Follow the instructions to install and adjust the 
  product. Adjust those controls that are covered in this 
  operating instructions as improper adjustment of other 
  controls may result in damage. If this happens, unplug 
  the set and refer to the service personnel.

- If the set is subject to impact or has been dropped to 
  have the cabinet damaged.

Where the mains plug or an appliance coupler is 
used as disconnect device, the disconnect device 
shall remain readily operable.
(* Where an all-pole mains switch is used as the 
disconnect device, the switch shall remain readily 
operable.)

Power and Plug

Do not allow anything to rest on or roll over the power 
cord and the signal cable.

Protect the power cord and the signal cable from being 
trampled.

Do not overload the power cord or the power outlet.

Do not expose the power cord and the signal cable to 
moisture. 

Power Cord and Signal Cable

Do not place the set on an unstable cart, stand, or table.

Place the set on a place that allows good ventilation.

Do not use the set near damp, and cold areas. Protect 
the set from overheating.

Keep the set away from direct sunlight.

Apparatus shall not be exposed to dripping or splashing 
and no objects filled with liquids, such as vases, shall be 
placed on the apparatus.

Do not use the set near dust place.

Use Environment

Hanging the TV Set on the Wall

Warning: This operation requires two people.

To ensure a safe installation, observe the following safety 
notes:

    Check that the wall can support the weight of the TV 
    set and wall mount assembly.

    Follow the mounting instructions provided with the wall 
    mount.

    The TV set must be installed on a vertical wall.

    Make sure to use only screws suitable for the material 
    of the wall.

    Make sure that the TV set cables are placed so that 
    there is not danger of tripping over them.

All other safety instructions about our TV sets are also 
applicable here.

Note

Graphics contained within this publication are 
presentation only.

Warning: the batteries shall not be exposed 
excessive heat such as sunshine, fire or the like. 

Summary of Contents for 28D2700












Reviews: