Attaching the TV Base
1.
Find a cloth covered table. Please lay the TV flat on the table with the TV screen facing down-
wards.
2.
If your TV comes with the neck pre-installed, then you may skip to step 3. To install the neck,
place it in the slot at the bottom of the back of the TV. Use four of the included screws (B) to
secure the neck to the TV.
3.
Install the TV base onto the neck of the TV with the protruding plastic block on the circular hole
facing downwards.
4.
Fit the included metal circular plate to the bottom of the base and screw in the 4 included screws
(A). Please make sure the rail on the metal plate fits the protruding plastic block on the base.
Also make sure the 3 small circular holes fit the neck piece.
Preparing your TV for a Wall Mount
1.
Find a cloth covered table. Please lay the TV flat on the table with the TV screen facing down-
wards.
2.
Locate the neck on the back of the TV and unscrew the 4 screws (B). The neck will come off
once the screws are removed.
3.
The TV uses
200mm horizontal by 100mm vertical
mounting specification. The screw size to
mount with the TV is
M4
. The mounting holes on the TV are
6mm
deep.
Please write down
your TV p/n number and s/n number (located on the back of the TV on a barcode sticker)
before you mount the TV.
Mounting screws and wall mount hardware are not included.
oCOSMO TV
Remote Control
TV Base
Screw Driver
Fine Thread Screws (B) x 4
Thick Thread Screws (A)x 4
AAA
Batteries
User’s Manual
Quick Start Guide
Warranty Card
Circular Metal Plate
Neck
CE3230 PACKAGE CONTENTS
INSTALLATION
Screws (B)
Screws (B)
Screws (A)
Screws (A)
QUICK START GUIDE
