Ludwig-Rinn-Straße 10-14 • D- 35452 Heuchelheim/Gießen • Phone: +49 6 41-9 62 84-0 • Fax: +49 6 41-9 62 84-28 • www.tci.de
Ludwig-Rinn-Straße 10-14 • D- 35452 Heuchelheim/Gießen • Phone: +49 6 41-9 62 84-0 • Fax: +49 6 41-9 62 84-28 • www.tci.de
12 / 15
13 / 15
7. Installing in the recessed housing
The four fixing screws of the luna should be already located in the screw holes of the
device. If the screws are not there, they will be included with the accessories of the
luna. Connect the supply cable to the power supply now. The device will start after being
switched on once the voltage supply is connected (see below).
The device should only be installed by authorised specialists and
electricians. tci GmbH cannot accept any liability for the mounted housing
and its function. Specialist personnel must inspect the device.
!
Install only when the supply cables are disconnected from the power.
The reset button can be accessed using the tip of a ballpoint pen
or the end of a paper clip. Do not exert too much force on the
button as it could damage the device.
8. Installation and initial commissioning
1) Connect the touch panel to your network.
2) Then connect the voltage supply. The operating system will boot up automatically.
Note:
Under certain requirements, this process may take several minutes during initial commis-
sioning, as drivers must configure themselves automatically. The touch screen does not
respond in this state.
9. Final installation step/cleaning and care
You can now remove the protective film from the front.
Never cover the air vents on the top and bottom of the device.
!
Cleaning and care of the front frame
Only suitable cleaning agents can be used for the cleaning and care of the frame.
Functions of the reset button when device
is switched on:
• Pressing resets the system and restarts
the device
Functions of the reset button when device
is switched off:
• Briefly pressing switches the device on
Reset
luna7-VI /
pureKNX-trend7
11.06.2014
Rev. 1.1
Oben/Top
Front
Seite/Side
Seite/Side
36mm
12mm
12mm
36mm
190mm
12
6
mm
Reset
Mini USB
Mikrofon/
Microphone
Helligkeitssensor/
Brightness sensor