Guida Rapida TCE KRONOS / Quick Guide TCE KRONOS Rev. 1.0 07/17 IT /EN
The battery chargers produced by T.C.E. Srl offer many unique features comprehensively described in the manual
found in the attached CD.
Carefully read these instructions to use the device at its best and avoid potential problems in future.
T.C.E. Srl strongly advises to carefully follow all information and advice mentioned to guarantee safe use of the device
The correct utilization of the device will increase its working life and maximize efficiency.
In case of suggestions, advices or error noticed in this manual, your notifications will be very much appreciated to
improve the quality of our service.
Thank you for your trust in choosing our product.
For further information, technical details, brochures or illustrative material visit our website
www.tcechargers.com
INSTALLATION
Make sure that the power supply connector and charging connector are installed. If not, contact a technician
to install the connectors properly dimensioned for the device and for the mains voltage network
Make sure that the mains voltage plug where the device is connected is properly grounded and protected by
adequate safety devices
Make sure that the size of the device is adequate for the battery connected to it
Make sure that the device is located in an adequate location for a proper use
Avoid the placing of the device in areas with sparks and/or flames because the battery generates explosives
gases during the charge
Make sure that the battery cells are in good condition and verify the presence of short circuits
Make sure that there are no objects on top of the battery cells before starting the charging cycle
For further information regarding the installation of the device consult the instructions manual found in the
attached CD
BATTERY CONNECTION
It is suggested to use the proper bi-polar connectors without the possibility of reverse polarity on the battery.
Verify also the correct connection of the cables in the connector’s contacts
CHARGING CYCLE
Once the battery is connected to the charger, if the battery voltage is inside an allowed range, the charge will
automatically begin
The charging process is automatically interrupted and the battery charger will stop the charge when the
battery is fully recharged
In case of values outside the allowed range or in case the charge reaches the safety timer, the charge will
automatically be interrupted
In case of power failure during the charging phase, the charger will automatically resume the charge when the
power failure is over
For the many display visualizations and data shown during the charging cycle, consult the instructions manual
found in the attached CD
NETWORK CONNECTION AND PROBLEM SOLVING
Before connecting the charger to the mains voltage, make sure that the voltage of the network is adequate for
the device
CAREFULLY READ THE FOLLOWING INSTRUCTIONS BEFORE CONNECTING THE DEVICE TO THE
MAINS VOLTAGE AND/OR TO THE BATTERY.
ALSO MAKE SURE THAT THE SIZE OF THE DEVICE IS ADEQUATE TO THE BATTERY CONNECTED
TO IT.
