4
DUPLICATOR User Manual
Connection
•
Connect a microphone to the MIC jack
•
Connect the OUT jack to a mixer, interface or active speaker
•
Connect power cable
(optional)
•
Connect a micro USB cable to a computer (optional)
Momentary Mode
The standard function of the footswitch is a latching style, meaning that each
press of the footswitch turns the doubling eff ect on and off . Alternatively, the
switch can operate in momentary mode, meaning that the doubling is only active
while the footswitch is held down. As soon as you release the footswitch, the
doubling eff ect is bypassed.
To switch the unit to momentary mode, hold the Tone button down while
powering the unit on. Repeat the process to return to latching mode.
Changing the Batteries
Duplicator can operate on 4 AA batteries. Remove the single screw on the bottom
of the pedal to open the battery door. Make sure to observe correct polarity when
inserting the batteries.
Auto Gain
Duplicator will automatically adjust the gain setting for your microphone,
eliminating the need for manual adjustments and ensuring that a good signal is
passed to the mixer without any unwanted distortion.
24V Phantom Power
Phantom power is always active on the Duplicator. This will power condenser
microphones, but will not aff ect dynamic mics either.
Mic Control
Mic Control allows you to control the eff ect's on/off status via an MP-75
microphone. Press and hold the footswitch while powering up the unit to
toggle Mic Control.
Note that when using a condenser microphone, Mic Control should be disabled to
prevent unwanted on/off switching.
Micro USB cable
MP-75 microphone
Mixing board
Power cable
2. Operation
Summary of Contents for DUPLICATOR
Page 6: ......
