![background image](http://html2.mh-extra.com/html/tc-electronic/tc-1210/tc-1210_instruction-manual_3842765006.webp)
2.
IN SEPARATE MODE:
Channel 2 left & right outputs.
Stereo jack wiring: LEFT OUTPUT = TIP, RIGHT OUTPUT =
RING.
OUTPUTS 1:
1.
IN NORMAL MODE:
Left output.
2.
IN SEPARATE MODE:
Channel 1 left & right outputs.
Stereo jack wiring: LEFT OUTPUT = TIP; RIGHT OUTPUT =
RING.
DIRECT MUTE:
Switch that mutes the direct part signal of the unit.
EX. SPEED:
Stereo jack to short the LFO sweep range 5 times.
EX. BYPASS:
Stereo jack to connect external bypass control.
FUSE
110/220VAC MAINS VOLTAGE SELECTOR.
3 PIN IEC MAINS PLUG.
HOW TO GET STARTED
1.
Before connecting power cord to the mains, check that the voltage selector on
pack panel is set at the appropriate range.
2.
Connect input signal source(s) and select INPUT MODE:
If mono signal sources use any of (or more to mix) the inputs.
If stereo signal source use IN1 for left and IN2 for right and press STEREO to
separate the left and right channels.
If two separate sources use IN1 for source 1, IN2 for source 2, press Stereo to
separate the left and right channels, and press SEPARATE and CROSS OFF
to make TC 1210 function as two independent chorus flangers.
3.
Connect outputs to a stereo- or two separate power amps:
If using the TC 1210 as one (mono/stereo in & stereo out) unit:
OUT1 = left, OUT2 = right
If using the TC 1210 as two separate (mono in - stereo out) effects, the
jackoutputs are used with the left outputs on the tips and the right outputs on
the rings.
Summary of Contents for TC 1210
Page 11: ......