-6-
TC3301 User's Manual
Rev. 1.4
9. Installation
A.
Connect the standard 12VDC power supply to the TC3301 (24VDC, 48 VDC, 125VDC or 115/230VAC
with an external power cube are optional).
B.
The "PWRA," and/or "PWRB," "1000M," "Vcc," LEDs should be lit.
C
. Use CAT 5E or 6 UTP cable to connect the TC3301 RJ-45 port to the 1000Base-T Port of your network
device. The "FDX," and "LNK," LEDs will be lit. If the LEDs are "Off," please verify the cable
connection and the power of the network device.
D.
Connect the optic cables according to the example diagrams shown on page 7. For example, on diagram
C; the local TC3301's optic "Tx" should be connected to the remote network device's optic "Rx" and vice-
versa.
E.
After step "D," the "FO" LED should light to indicate that the optical idle signal is being received.
F.
Create some activity on the Ethernet, the "ACT" LED should be lit.
Note: As the Ethernet activity going through the RJ-45 port becomes greater, this LED will become brighter.
G.
Double-check all LEDs according to the following:
The "PWRA," and/or "PWRB," "Vcc," "FO," "1000M," "FDX," "LNK," and "ACT" LEDs should be lit.
The "FO" LED will be lit when the optic side has activity and/or fiber optic cables are connected.
The "ACT" LED will be lit when the UTP side has activity.
