18 |
P a g e
G e n e r a l D a t a H e a l t h c a r e , I n c .
Display Panel
•
The value in the first line of the display window is the set sectioning or
trimming thickness.
•
The value in the second line of the display window is the section or trim
counter and section or trim thickness sum (total advance).
•
The system is in trimming mode after the instrument is energized.
Indicator Light
•
POWER LED - Indicates the unit being powered ON.
•
ERROR LED - Indicates coarse feed operation error and sounds an
alarm at the same time.
•
LOCK LED - Indicates the handwheel is locked and it will not perform
automatic sectioning.
Sectioning Mode Indicator Light
Using the MODE button, the operator can choose between 3
sectioning modes that are then indicated with corresponding LED
lights:
•
CONT - The unit will go into continuous mode. This indicates that once
the operator presses the RUN button, the unit will automatically section
until the operator presses the RUN button again to stop.
•
SINGLE - The unit will go into single sectioning mode. This indicates
that once the operator presses the RUN button, the unit will take a single
section from the specimen until the RUN button is pressed again to take
another section.
•
MANUAL - The unit will go into manual mode which allows the
operator to use the hand wheel to section the specimen.
Sectioning Mode selection button
•
Press the MODE button to choose desired operating sectioning mode:
CONT, SINGLE, OR MANUAL
