PAGE 5
Settings mode (accessible via the DPI)
The settings mode of the DPI1C is primarily meant for installers when installing the system,
and for users who do not use the Desk Connect™ App.
End users should not mix the ways to set up/configure the DPI but use either the
Desk Connect™ App or the DPI settings mode.
If you set up the DPI1C via the settings mode and then connect to the Desk
Connect™ App, favorite positions and units set in the app will override the favorite
positions and units selected via the DPI settings mode.
Via the settings mode of the DPI1C you can access the following menus:
• HEIGHT
• UNITS
• FAV. POS.
• LIMITS
• RESTORE
• EXIT
The setup menu
1. To access the settings mode, press the connect button and, at the same time, tilt the
paddle down for 3 seconds.
2. Tilt the paddle up or down to scroll through the menus.
The settings mode is identified by the icon in the upper left corner of the display.
3. Press the connect button to select a menu/setting.
After 30 seconds of inactivity, the DPI automatically exits the setup menu.
Height
The first menu is ‘HEIGHT’. If the height shown in the display is not correct, it can be
adjusted via this menu.
1. Measure the height from the floor to the tabletop.
2. Press the connect button to enter the menu.
3. Tilt the paddle up or down to adjust the displayed height.
4. Press the connect button to save the new height.
Units can be changed in the ‘UNITS’ menu.
Revisit your favorite positions if you change the desk height.
