12
Owner’s Manual
COMPACT TILLER AND CULTIVATOR
Get parts online at
www.tazzoutdoorproducts.com
or Call
800-345-6007
M-F 8-5 CST
FIGURE 6
FIGURE 6A
Align lower handlebar assembly mount holes with lower
mount holes on pulley box. Place one M8 x 25 mm Flat
Washer on one M8 x 40 mm Hex Bolt and insert through
lower mount hole of lower handlebar assembly and pulley
box. Place one M8 Nylock Nut on bolt and tighten with
two 13mm wrenches. Repeat for other side.
C
F
I
K
H E
A
Check that arrows are pointing in the direction of forward
rotation and slide left tine set over tine shaft sleeve, align
mounting holes with the left tine shaft, and secure with
the M10 x 45 mm Hex Bolt, Spring Lock Washer, and Ny-
lock Nut. Tighten with two 16mm wrenches. Repeat for
right tine set on right tine shaft.
16
mm
2X
13
mm
2X
FIGURE 7
Rotate lower handlebar assembly away from engine to provide adequate clearance to install side tine shields Slide left and
right side shields onto center tine shield. Align side shield grooves with center tine shield and push until an audible click is
heard and/or felt. This indicates that the tine shield has engaged with the shield lock and is secured all the way on. Rotate
lower handlebar assembly up towards engine and insert hand knob bolts through upper mount holes and tighten.
NOTE: Hand knob bolts can be inserted into one of two sets of holes depending on desired handlebar height.
1st
2nd
