12
Models RD30/RC25
Operating Procedures
150706
Step 4
Before installing the beater assembly, check the
scraper blades for any signs of wear or damage. If a
scraper blade is nicked or worn, replace both blades.
Check the scraper blade clips to make sure they are
not bent and the slot is even for the entire length of the
clip. Replace any damaged clips.
Figure 5
If the blades and clips are in good condition, install the
scraper blade clip over the scraper blade. Place the
rear scraper blade over the rear holding pin (knife edge
to the outside). Holding the blade on the beater, turn
it over and install the front blade the same way.
Figure 6
Step 5
Holding the blades in position, insert the beater
assembly into the freezing cylinder, and slide the
assembly into position over the drive shaft. Turn the
beater slightly to be certain that the beater is properly
seated.
Figure 7
When in position, the beater will not protrude beyond
the front of the freezing cylinder.
Figure 8
Step 6
Install the plastic guide bearing on the short end of the
torque rotor. Slide the o- ring into the groove on the
long end of the torque rotor and lubricate the o- ring.
Do not
lubricate the guide bearing.
Figure 9
