15
Model C043
Operating Procedures
Step 3
Slide the seal over the shaft and groove until it
snaps into place.
Figure 7
Step 4
Fill the inside portion of the seal with 1/4” (6 mm)
more lubricant and lubricate the flat side of the seal
that fits onto the rear shell bearing.
Figure 8
Step 5
Lubricate the beater shaft.
IMPORTANT! DO
NOT lubricate the hex end of the beater shaft.
Figure 9
Step 6
Inspect each scraper blade for any nicks or signs of
excessive wear. If any nicks or signs of wear are
present, replace the blade.
Figure 10
Summary of Contents for Model C043
