V
-
21A
14
SETTING UP & WELDING
Switch the controller ON.
Select the required welding voltage by
turning the selector knob. The voltage is
adjustable between 35 and 200 volts in 1
volt steps.
See pages 16 to 22 of this guide for suggested
settings.
Ensuring that a stud has been loaded, position the stud at the location on the work
piece where it is to be welded. Press down firmly on the pistol until all three points
of the tripod (or the face of the nose cone if using instead) are firmly in contact
with the work piece. Do not drape or wrap the pistol cables over or around yourself
whilst operating the equipment. Allow the cables to trail naturally to the floor.
Press the trigger.
Once welding has taken place. Draw the
pistol off the welded stud. Always lift the
welding pistol vertically from the welded
stud. Failure to do this may cause damage
to the chuck, which will result in the chuck
and stud arcing together during subsequent
welds and thereby reducing the working life
of the chuck.
Summary of Contents for M8
