Taylor C001, Operator'S Manual

Page: 23 / 44

Section 6
6-1
Models C001 and C002
Operating Procedures
6
Operating Procedures
The Model C001 is a single-flavor custard freezer with a
20 qt. (18.9 L) hopper. The Model C002 is a two-flavor
custard freezer with two 20 qt. (18.9 L) hoppers. Mix
flows by gravity through an adjustable flow regulator into
the freezing cylinder(s). These machines have been
designed to produce rich-tasting custard that can be
drawn off and served from a dipping cabinet. The overrun
is low; typically 15-20%, depending on the mix
formulation and the finished product temperature of 17°F
to 19°F (-8.3°C to -7.2°C).
The Model C002 has been selected to illustrate the
pictured step-by-step operating procedures for both
models contained in this manual. These models, for
practical purposes of operation, are the same.
We begin our instructions at the point where we find the
parts disassembled and laid out to air-dry from the
previous brush-cleaning.
The following procedures will show how to assemble the
parts into the freezer, sanitize them, and prime the
freezer with fresh mix.
If you are disassembling the freezer for the first time or
need information to get to this starting point in our
instructions, turn to page 6-7, “Disassembly,” and start
there.
Assembly
WARNING! Make sure the power switch is in
the OFF position. Failure to follow this instruction may
result in severe personal injury from hazardous moving
parts.
1. Install the driveshaft. Lubricate the groove and
shaft portion that comes in contact with the bearing
on the dasher driveshaft. Slide the seal over the shaft
and groove until it snaps into place.
Do not lubricate
the hex end of the driveshaft. Fill the inside portion of
the seal with 1/4 in. (6 mm) more lubricant and
lubricate the flat side of the seal that fits onto the rear
shell bearing.
Note: When lubricating parts, always use an
approved food grade lubricant (example: Taylor
Lube).
Figure 6-1
Insert the driveshaft into the freezing cylinder, hex
end first, and into the rear shell bearing until the seal
fits securely over the rear shell bearing. Engage the
hex end firmly into the drive coupling. Be sure the
driveshaft fits into the drive coupling without binding.
Figure 6-2
2. Install the short baffle into the freezing cylinder,
narrow end first. Slide it over the end of the
driveshaft.
Apply the appropriate
Taylor approved food safe lubricant.