Taylor 8757, Original Operating Instructions

Page: 47 / 58

Section 8
8-1
Models 8752, 8756, and 8757
Troubleshooting Guide
8
Troubleshooting Guide
Table 8-1
Problem Probable Cause Remedy
Page
Ref.
1. No product is being
dispensed.
a. Low on mix. The MIX OUT light is
on.
a. Add mix to the mix tank and press the
AUTO button.
5-1
b. The power switch is in the OFF
position.
b. Place the power switch in the ON
position and press the AUTO button.
- - -
c. The beater motor is out on reset. c. Reset the freezer. 5-1
d. The beater assembly is rotating
counterclockwise.
d. Contact service technician to correct
rotation to clockwise.
- - -
e. Insufficient mix in the freezing
cylinder.
e. Go to problem 2.
- - -
f. Restriction in the door spout. f. Remove the draw handle and raise
the draw valve all the way up to
remove restriction. Never put objects
or fingers in door spout.
- - -
g. Machine is unplugged. g. Plug machine into the wall receptacle. - - -
h. Circuit breaker is off or the fuse is
blown.
h. Turn the breaker on or replace the
fuse.
- - -
i. The mix probe was not installed
properly or was damaged.
i. Check the mix probe installation.
6-12