Trouble-Shooting
Low Battery Warning
Disconnected Signals
If the receiver unit does not receive a transmission from a remote unit
channel for 10 minutes, the display will show dashes. To correct this
problem:
1.
Go to the remote location of that channel to check that the unit is
properly positioned, within the appropriate transmission range.
2.
If new batteries are faulty on the initial installation, install fresh
batteries. If you did not notice the Low Battery icon warning and the
product performed correctly after initial set up, the batteries have
lost their charge. Replace the batteries.
3.
Check to make sure the transmission path is clear of obstacles and
interference.
Note:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
Modifications not authorized by the manufacturer may void user's
authority to operate this device.
FCC ID: L5CW132TX-2 (wind gauge transmitter)
When the batteries on the receiver unit or the remote unit are low, the
Low Battery icon ( ) will light up on receiver unit. If the batteries for
the indoor receiver are low, the Battery Icon near the indoor
temperature display will light up. If the batteries for the remote Wind
Gauge Sensor are low, the Battery Icon near the Ch 1 indicator will
light up. If there are 1 or 2 additional temperature/humidity sensors in
use (
purchased separately
), a Battery Icon appearing near “Ch 2” or
“Ch 3” indicates the batteries in that remote sensor are low.
Please Note: Wind direction calibration is required before battery
replacement in the Wind Gauge Sensor. See the section on
“Calibrating the Wind Gauge Sensor”
.
16
