![background image](http://html2.mh-extra.com/html/taylor-dunn/tc-30/tc-30_operators-manual_3766345032.webp)
Page 32
Tiger TC-3060 Operator Manual
MT-030-60-E
Stopping
Release the throttle pedal and use your right foot to press the brake pedal. The amount of force
required to stop the vehicle will vary depending on the environment and load on the vehicle.
Parking
1. Bring the vehicle to a stop at an authorized parking space.
2. Firmly set the parking brake.
3. Place the shift lever in Park or Neutral if Park is not available.
4. Turn the ignition switch OFF.
Note: If parking this vehicle on an incline, turn the wheels to the curb, or block the wheels.
Parking with Engine Running
It is not recommended to leave the approved operator position while the engine running. Follow
the following steps if you find it necessary to leave the engine running:
1. Place the shift lever in Park or Neutral if Park is not available.
2. Firmly set the parking brake.
3. If Park is not available then block the wheels immediately after leaving the approved operator
position.
Emergency Engine Kill Switch
The Emergency Engine Kill Switch is optional
and may ne be installed on your vehicle.
This vehicle may be equipped with an optional
Emergency Engine Kill Switch. When activated,
the Emergency Kill Switch will immediately stop
the engine.
The emergency engine kill Switch should
be used if the vehicle starts to operate in an
unexpected manner or if there is an odor
or sound that may indicate an overloaded
electrical circuit. If any of the above occurs,
immediately and safely pull to the side of the
road and stop. Then push on the switch knob,
turn the ignition switch OFF and exit the vehicle.
Do not reengage the switch until the vehicle
has been inspected by a qualified technician.
The emergency engine kill Switch should only be activated if the vehicle must be immediately
stopped. Do not use the switch when only parking the vehicle.
The location of the switch will vary depending on vehicle configuration. The
switch is a large red knob located within reach of the driver. See the illustration
to the left for a typical kill switch knob.
Collisions or Accidents
A collision or accident may damage the electrical circuits or battery resulting in a fire hazard or
chemical spill. In the event of a collision or accident, immediately turn the ignition switch OFF, set
the park brake, then exit the vehicle.
Call emergency personnel if there is any indication of smoke, burning smell, electrical arcing, or
leaking fluid.
Tip Over
In the event of a tip over AND the vehicle is equipped with an Operator Protective Structure
(OPS), stay inside the confines of the vehicle. Exit the vehicle after the vehicle has come to a
complete stop.
In the event of a tip over and the vehicle IS NOT equipped with OPS. Quickly exit the vehicle
and quickly move out of its path.
Unless in an emergency, do not activate
the emergency engine kill Switch while
the vehicle is in motion.
This vehicle is equipped with power
hydraulic steering and power hydraulic
assist brakes. If turned off, the steering
will be very heavy and braking force will
be diminished required much more foot
pedal pressure to apply the brakes. This
will increase distance required to stop
and may result in collision and severe
bodily injury.
WARNING
Summary of Contents for TC-30
Page 15: ...Page 15 Tiger TC 3060 Operator Manual MT 030 60 E HOW TO IDENTIFY YOUR ENGINE TRANSMISSION...
Page 18: ...Page 18 Tiger TC 3060 Operator Manual MT 030 60 E...
Page 42: ...Page 42 Tiger TC 3060 Operator Manual MT 030 60 E Engine Dipstick Locations...
Page 59: ...Page 59 Tiger TC 3060 Operator Manual MT 030 60 E...