Taylor-Dunn SS5-34, Operation, Troubleshooting Manual

Page: 70 / 200

3-46
SECTION 3
28. After the flange side bearing is seated install the snap ring.
29. Repeat procedures for opposite side.
30. Align the final drive gear mounting holes with the differential case,
install the four bolts through the differential case, and secure the
drive gear in place by tightening the nuts.
NOTE: The bolts should be installed from the flange side of
the differential case.
31. Press the differential bearings onto the differential case.
32. Position the drive housing with the opening facing up and install the
differential assembly.
33. Install the differential bearing caps
NOTE: Remember that the bearing caps are marked. Be sure
to reinstall the bearing caps back into their original position.
34. Install the bearing cap screws and torque them to 35-45 ft. lbs.
35. Install the cover plate and torque the cover plate screw to 18-28 ft.
lbs.
36. Install new intermediate bore plugs into both sides of the housing.
NOTE: Bore plugs should be firmly against the snap rings
when fully seated.
37. Fill differential housing with 10 ounces of SAE 30 motor oil.