Taylor-Dunn SS5-34, Operation, Troubleshooting Manual

Page: 105 / 200

ELECTRICAL TROUBLESHOOTING
SECTION 4 Special Troubleshooting PAGE 1
SYMPTOMS GO TO
Ø
Runs slow in both directions plus high armature and field current in both
directions. NOTE: Armature and field current should be equal.
MOTOR
Ø
Runs slow in both directions plus high armature current in both directions.
NOTE: Field current will be very low.
SOLENOIDS
Ø
Ø
Runs normal in one direction only plus runs slow or lacks power in the opposite
direction with high armature current in the opposite direction or;
Accelerates slowly and exceeds normal speed in the opposite direction with high
armature current only. NOTE: Field current will be very low in the opposite
direction.
SOLENOIDS
Ø
Accelerates slowly and exceeds normal speed in both directions plus high
armature current. NOTE: Field current will be very low.
SOLENOIDS
Ø
Full speed only.
PMC CONTROL
Ø
Does not run in either direction plus there is noise from motor (hum or whine)
with high field current and low armature current.
PLUGGING DIODE
Ø
Excessive spark when connecting battery
ISO
Ø
Does not run or runs very slow with low motor current and high battery current.
FREEWHEEL DIODE
Ø
Jumps into high speed when direction is selected after depressing the accelerator
pedal.
HPD
Section 4-Special Troubleshooting Guide
This section is specific to the symptoms listed below. Each troubleshooting sequence assumes
that all listed symptoms are present. Do not use this section unless the truck has all listed
symptoms.
Section 4, Special Troubleshooting
Table of Contents
PMC CONTROL ------------------------------------------------ 2
PLUGGING DIODE -------------------------------------------- 4
FREEWHEEL DIODE ------------------------------------------ 5
ISO ---------------------------------------------------------------- 6
SOLENOIDS ----------------------------------------------------- 8
MOTOR ----------------------------------------------------------- 11