Taylor-Dunn SC-011-59, Operation, T Roubleshooting And Replacement Parts Manual

Page: 66 / 206

Transmission
Transmission Page 4
CHECK THE OIL LEVEL
NOTE: The oil level in the chain case is maintained by the transmission.
Oil is pumped from the 3rd member into the chain case housing. It
is not necessary to check the oil level in the chain case.
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
6. Park the vehicle on a level surface.
7. Place a small oil drain pan under the drive housing.
8. Remove the drive housing level plug.
9. A small amount of oil should come out. This
indicates the correct oil level.
NOTE: If a large amount of oil comes out, then
let it drain to the proper level and
replace the level plug.
If no oil comes out, then fill the drive to
the proper level and replace the level
plug.
Typical location of oil plugs. The actual
location of the level plug will vary depending
on your vehicles configuration.
T
A Y
L OR - DUN
N
Th
e
B
e
st
W
ay
To
Go About
Yo
ur
Bu
si
n
e
s
s
R