![background image](http://html2.mh-extra.com/html/taylor-dunn/c0-425-48/c0-425-48_operators-manual_3776176021.webp)
Page 21
Huskey C-425 Sevcon DC System Operator Manual
MC-425-12
SmartView® Dash Display
The Smart View Display (SVD) functions as a Battery Status Indicator (BSI), Hour Meter (HM),
speed controller status monitor, and as an optional maintenance monitor feature. The operation of
each of these functions is described below.
BSI
A bar graph representing the current state of charge is located across the top of the display.
When the batteries are fully charged, all segments of the bar graph will be on. As the batteries
are used, segments will turn off in the order of right to left.
When the batteries are discharged to 75%, the last three segments will flash indicating that
you are approaching the end of the battery cycle. At this time, the vehicle’s batteries should be
charged as soon as possible.
At 90%, all segments will flash and the vehicle’s speed will be reduced. At this time, the vehicle
should be removed from service for charging. Discharging beyond 90% will result in damage to
the batteries that will shorten the battery life-span.
Note: The battery status gauge as well as any faults indicating low battery voltage will not reset
until the batteries have successfully completed a charging cycle.
Hour Meter
Depending on the revision level of the controller, there are one or two hour meter functions, Key
Hours and Run Time Hours (see note below).
Run Time Hours is the accumulated length of time that the vehicle has been in operation. Time
is accumulated when the FS-1 switch in the accelerator module is closed.
The Run Time Hours will be displayed as indicated by the Run Time Hours Indicator located at
the left of the display. The icon represents a motor symbol with a “T” in the center.
System Fault Monitor
The display will indicate a fault code whenever the control system
logic detects a problem with the control system. A fault code is
being displayed whenever the Fault Code Indicator (the letter ‘F’)
is visible at the left of the numeric display. Refer to the fault code
table in this section for a summery description of the fault codes.