Taylor-Dunn BG-015-00, Operation, T Roubleshooting And Replacement Parts Manual

Page: 99 / 174

Maintenance, Service, and Repair
Suspension Page 3
REPLACE THE FRONT SPRINGS
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.
If a spring has failed or is fatigued, then it is recommended that both front springs are replaced as a set.
HINT : In most vehicles it will be easier if the springs are replaced one at a
time.
6. Raise the front of the vehicle and support with jack stands.
7. Tie up or support the front axle so it cannot fall out of the vehicle.
8. Unbolt the spring from the front axle beam.
9. Support the spring so that it cannot fall out of the vehicle.
10. Remove the lower bolt from the spring hanger.
11. Remove the spring bolt from the other end of the spring and remove the spring from the vehicle.
1. Make sure the key-switch is in the “OFF” position, then remove the
key.
2. Place the Shift lever in the neutral position.
3. Set the park brake.
4. Place blocks under the rear wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the battery.