Taylor-Dunn B0-T48-48 Taylor Truck T48, Operation Manual

Page: 90 / 240

SECTION 3 PAGE 54
MB-T48-01
Motor Removal
It is not necessary to remove the drive assembly to perform this procedure
in most cases. However, if the vehicle is equipped with an optional cargo
box, it may be necessary to lower the drive assembly in order to access
the motor.
6. Remove the wires from the motor.
NOTE : Label the wires connected to the motor to insure
that they are returned to their proper location on the
motor during reassembly.
7. If equipped with an automatic electric brake refer to the
section on removing the automatic electric brake.
8. Remove the motor mounting bolts and motor support bracket
u-bolt from the drive and slide the motor off of the input
shaft.
9. Install the new motor or reassemble in reverse order.
NOTE
: Apply grease to the input shaft.
10. Reconnect the main positive and negative cables at the
batteries.
11. Remove the blocks from behind the wheels.
12. Release the park brake and test drive the vehicle.
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle
movement.
5. Disconnect the main positive and negative cables at the
batteries.
Do not apply grease to the motor collar. Applying grease to
the motor collar may cause damage to the motor bearings.