25
Service of batteries or circuit board
1. Place trolley on table/floor with full access to the underside.
2. For change of batteries/controlboard, unscrew the left cover underneath the chassis (view from
operator side).
3. Remove batteries carefully and but battery pack on a table/floor.
4. Do the repair/change of needed parts on battery pack.
5. Place battery pack back into place and secure all screws firmly.
6. Lower the tool (without load) until it hits a surface or object close to the ground to check that the
tipping safety function is working properly.
• Always disconnect all cables to the bat-
tery before proceeding with any service/
repairs.
Changing the belt
1. Remove the two screws attaching the belt to the sleigh. Release the belt from the shaft.
2. Unwind (manually) the remaining part of the belt from the attachment in the centre of the
chassis.
3. Remove the two screws holding the shaft to release the belt completely.
4. Attach the new belt to the chassis shaft. Install the other part of the belt to the sleigh shaft and
mount all screws.
• Move the platform into the lowest position
before starting with the belt charge.
• Make sure that belt is wounded up in cor-
rect direction when changed.
Manual CR80 GB update 2019.indd 25
2019-09-11 14:18:44
