Taurus TF-X7.1, Assembly And Operating Instructions Manual

Page: 14 / 40

X7.1
14
2.3 Assembly
Before assembly, take a close look at the individual assembly steps shown and carry out the assembly
in the order given.
L
NOTICE
First loosely screw all parts together and check that they fit properly. Tighten the screws using
the tool only when you are instructed to do so.
Step 1: Assembly of the console mast
1. Move the console mast cover (41) as far
as possible on the console mast (10).
L
NOTICE
Make sure that the console mast cover
(41) points in the correct direction.
2. On the upper opening of the frame (1),
you will find a console cable (32). Unwind
the console cable (32) and smooth it
out in order to then thread it from the
bottom to the top through the console
mast (10).
3. Assemble the console mast (10) on the
designated bracket on the frame (1) with
four hexagon bolts (70), four washers
(97), two hexagon bolts (70) and two
spring washers (102).
࣑
ATTENTION
Be careful not to pinch the cables in the
following step.
4. Mount the console (31) on the console
mast (10) with the four screws (78) pre-
mounted on the bracket.
5. On the upper opening of the console
mast (10), there are three cables, two
hand pulse cables (37-3) and a console cable (32). Connect this cable with the corresponding
cables on the backside of the console (31).
L
NOTICE
The plugs are arranged so that they cannot be incorrectly inserted in each other.
6. First store the excess cable in the console mast (10). Then fasten the console (31) on the console
mast (10) with four M5 x 10mm screws (78).
7. Tighten all screws with the tool.