Taurus TF-PTT0209, Assembly And Operating Instructions Manual

Page: 17 / 28

17
4.2 Faults and Fault Diagnosis
The equipment undergoes regular quality controls during production. Nevertheless, faults or
malfunctions may occur. Frequently, individual parts are responsible for these disturbances, an
exchange is usually sufficient. Please refer to the following overview for the most common errors and
how to correct them. If the equipment still does not function properly, contact your contract partner.
Fault Cause Solution
Grinding noises
Cables or pulleys are running
not correct or are damaged
Visual inspection of the cable
routing or the pulley guidance
Weight is hanging in
the air
Cable too tensioned Readjust cable tension
Cable without tension Cable too loose Readjust cable tension
Squeaking & cracking
noises
Loose or too tight screw
connection
Check or lubricate screw connection
4.3 Maintenance and Inspection Calendar
To avoid damage from body sweat, the equipment must be cleaned with a damp towel (no solvents!)
after each training session.
The following routine tasks must be performed at the specified intervals:
Part Weekly Monthly Quarterly Half-yearly Yearly
Screw connections
I
Cushion C I
Legend: C = clean; I = inspect
5 DISPOSAL
At the end of its operational life, this equipment cannot be disposed of in normal household waste.
Instead, it must be disposed of via an recycling centre. Further information can be obtained from
your local authority‘s recycling service.
The materials can be recycled as per their symbols. Through the reuse, recycling
of materials or other forms of recovery of old equipment, you make an important
contribution to the protection of the environment.