Taurus SESS7140, Assembly And Operating Instructions Manual

Page: 22 / 44

002 Guide rod 2
003 Guide rod fixing sleeve 2
014 Bumper Φ38*Φ21*10 2
020 Select Pin Set 1
021 Hexagon Socket Set S with Cone M8*20 2
028 Split Washer d=20 2
54 10lb counterweight 1
55 10lb weight stack plate 13
85 Hex socket head cap screw M10*25 4
91 flat washer Φ20*Φ10.5*2 4
94 spring washer M10 4
107 Four wire hole plate 2
No. Name Specification Qty.
22
Rotary Hip
Step 7: Assembly of the Weight Stack Plates and Labels
L
NOTICE
The guide rods are pre-assembled to the frame.
1. Assemble both wire hole plates (107) to the door frame (001) by using four screws (85), four
spring washers (94) and four flat washers (91).
2. Disassemble the upper part of the guide rods (002) by removing the socket set (021), the guide
rod fixing sleeves (003), the split washers (028) and the bumpers (014).
3. Slide the 13 weight stack plates (55) onto the guide rods (002).
4. Slide the counter weight (54) onto the guide rods (002).
5. Insert the selector pin (020) into any desired hole of the weight stack plates (55).
6. Slide the previously removed bumpers (014) back onto the guide rods (002).
7. Fix the guide rods (002) to the upper part of the frame (001) with the previously removed socket
sets (021), guide rod fixing sleeves (003) and split washers (028).
8. Screw in the cable end (51) into the counterweight (54).
9. Wipe the front surface of the weight stack.
10. Peel off the adhesive back sheet from the label and make sure the label remains attached to the
application tape.
11. Align the center hole of the label with the weight stack center hole.
12. Line up the first label to the hole of the top plate.
13. Make sure the label is straight, then slowly press into place.
14. Gently remove the application tape and rub each label firmly against the weight stack.
15. Allow the labels to stand for at least 24 hours.