Taurus SESS7140, Assembly And Operating Instructions Manual

Page: 18 / 44

78
65
18
Rotary Hip
Step 4: Assembly of the Pulleys and Cable Routing
L
NOTICE
+ The majority of the pulleys are pre-assembled when delivered. These pulleys need to be
disassembled in order to perform the cable routing.
+ The two pulleys (012 and 013)
for the frame are not pre-
assembled
1. Route the cable (51) over the
pulley set (013) and assemble the
pulley set (013) to the upper side of the
frame (001) and pulley baffle (004) with the pre-
assembled screw (026), two flat washers (031)
and one nut (034-1).
2. Route the cable (51) down and under the pulley set (012)
and assemble the pulley set (012) to the lower side of the
frame (001) with the pre-assembled screw (025), two flat
washers (031) and one nut (034-1).
3. Disassemble the pulley (78), route the cable (51) around and
reassemble the pulley (78).
4. Disassemble the pulleys (65), route the cable (51) around
and reassemble the pulleys (65).
5. Attach the lower cable end (51) to the adjusting shelves (38).