Taurus Multi-gym WS7, Assembly And Operating Instructions Manual

Page: 16 / 68

WS7
16
Step 2: Assembly
1.
Guide the 14 6-kg weight plates (11) carefully down the two guide rods (2); finally
set the single 8-kg weight stack (12) on the top.
Ideally, the weight stacks should be labeled before they are put in place; arrange
the stacks so that the heaviest weight is at the bottom. The writing should be
visible from the front.
2.
Remove the screw from the topmost weight stack (12), lower the steel lifting
rod/strut (10) into the central opening in the weight stack and secure it in place by
screwing the screw back into the upper weight stack (12).
3.
Secure the two upper rubber stoppers (7) in the topmost hole in the guide rods
(2) using – in each case – one hexagon bolt M8* (8), two
washers Φ8 (14) and one locking nut (9).
4. Insert the magnetic safety pin (86) into the front of the
second-to-bottom weight plate.