29
Required parts for step 10:
Step 10:
Assembly of the cable
1. Lay out and unwind cable. Slide the chrome pulley to one end of the cable. Slide the other two
pulleys to the other end of the cable. This keeps the cable unwind during installation.
2. Mount the chrome pulley with bracket on the upper right frame with a thread screw and a cap
nut, see image. The large snap hook must be in front and the nut in the back. You must be able
to spin the pulley. Note: You may need a ladder for this step.
3. Moving the cable.
L
NOTICE
If you attach the cable to previously assembled pulleys, it may be easier if you loosen the nuts
and pull out the pulley. After you have guided through the cable, mount the pulley and the
bracket again before you continue.
a.
Guide the cable downward through the pulley above the perforated sheet.
b.
Guide the cable from the outside passing the upper and lower supporting
bars and then inside to the lower pulley.
c.
Guide the cable upward around the pulley to the inner side of the pulley on the
swivel arm.
d.
Guide the cable downward through the pulley on the swivel arm to the hook on
the rear side of the main frame.
Hook the pulley on the cable set on the hook on the rear end of the base frame
by loosening the Phillips screw until the hook can be mounted on the pulley on
the hook from the main frame. Tighten the Phillips screw so that the pulley can
not loosen from the hook.
4. Repeat steps 1-3 for the left side.
5. Now tighten all screws and nuts. Make sure that the cable does not get stuck.
࣑
ATTENTION
Now tighten all screws and nuts that were only slightly tightened in the previous steps. The
corresponding screws are marked in the figure with a black dot.
Summary of Contents for Multi-gym UltraForce
