Taurus Homeland Parking, Manual

Page: 11 / 56

inside the appliance.
ASSEMBLING THE WALL BRACKET:
-The appliance has a wall bracket (K) which
must be fixed to the wall.
-Fix the wall bracket as you think appropriate,
using plugs, screws, and adhesive…
-Place the support by matching the holes with
the rawlplugs and screw in firmly.
-Make sure that the bracket is firmly fixed; it
should be able to support twice the weight of
the appliance.
-Fit the appliance into the wall support.
CHARGING THE BATTERY
-Caution: A new battery is not fully charged and
must therefore be charged before the applian-
ce is used for the first time.
-Charge the battery at an atmospheric tempera-
ture of between 4 and 40ºC.
-Plug the charger into the mains.
-A pilot light will come on to indicate that the
charger is ready to begin charging the battery.
-Approximately 4 to 5 hours are needed for a
complete charge of the battery. Never attempt
to over-charge the battery (although it is re-
commended that the first charge of the battery
be of 6 hours in duration).
-Plug the charger of the vacuum cleaner (L) into
the battery charging connector (M) of the ap-
pliance, located on the back of the appliance,
under the battery. (Fig.1)
-NB: Do not use the appliance while it is
connected to the charger.
HOW TO CHECK THE BATTERY’S CHARGE
LEVEL:
-Start the appliance by pressing the start / stop
button. (G)
-If all six lights 0-100 (F) light up it means a full
charge level.
-If only one pilot light lights up this means that
the battery has very little power remaining.
-If no pilot light lights up, this means that the
battery is completely flat.
-NB: For a long battery life, it is advisable to
charge the battery, only, when it has run out
completely.
ASSEMBLING THE BATTERY/S
-Caution: During the handling of batteries, do
not touch both poles at the same time, as this
will provoke the partial discharge of the stocked
energy therefore affecting longevity.
-Put the battery in its compartment, respecting
the polarity.
INSTRUCTIONS FOR USE
BEFORE USE:
-Make sure that product’s packaging has been
removed.
-Before using this product for the first time, it is
important to make a full charge of batteries.
-Prepare the appliance according to the function
you wish to use:
VACUUMING FUNCTION:
USE:
-Turn the appliance on, by using the on/off
button.
-Select the desired speed by sliding your finger
on the speed selector (N). (Fig.2)
FITTING AN ACCESSORY TO THE HAND
VACUUM:
-The hand vacuum is designed in such a way
that it allows the following accessories to be
fitted: (use the combination that best meets
your requirements). (Fig.3)
-Furniture brush: Equipped with a brush at the
end, which brushes the surface as it is used.
-Crevice nozzle: Specially designed for getting
into cracks and difficult corners.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
-Turn the appliance off using the on/off button.
-Remove the battery from the appliance if you
are not intending to use the appliance during
an extended period.
-Clean the appliance.
CLEANING
-Disconnect the battery charger from the mains
and allow it to cool before undertaking any
cleaning task.