9
The earth has to be connected!
If the device will be directly connected with the local power supply network,a disconnection
switch with a minimum opening of 3mm at every pole has to be included in the permanent
electrical installation.
The device must only be connected with an electric installation carried out in compliance with
the IEC-standards,the electric installation must be equipped with RCD with a maximum fault
current of 20mA.
Lighting effects must not be connected to dimming-packs.
Strobe effects:
The Cyclone 1320 offers strobes effects from the beam with variable flash rate,flash duration and
intensity.It also offers the following pre-programmed effects:
-Ramp up/down intensity modulation effects
-Random flashes
-Lightning-simulates the instantly recognizable dirty flash or a lightning strike
-Spikes-low-intensity light output with high-intensity flashes.
Blinder effects
To obtain a continuous blinder effect,set flash duration to a long value and flash rate to a high
frequency value so that flashes overlap and merge into continuous light output.
Several built-in programming
Operation
After you connected the Cyclone 1320 to the mains,it starts running.
The LED display lights up and you can choose the desired mode via the buttons
MODE,UP,DOWN and ENTER.
The device has two operating modes,it can be operated in stand alone via LED display with
operating buttons or in DMX controlled mode via lighting controller.
Stand-alone Mode:In the stand-alone mode,the device can be used without a
controller,disconnect the device from the controller.
Master/Slave operation
The master/slave operation enables that several devices can be synchronized and controlled by
one master device.
On the rear panel of the device you can find an XLR jack and an XLR plug,which can be used for
connecting several devices.
Choose the device which is to control the effects,this device then works as master device and
controls all other slave devices,which are to be connected to the master device via a
DMX-cable,connect the OUT jack with the IN plug of the next device.
Set the desired Master mode for the master-device and set the DMX address 001 for all
slave-devices.
