33
After Sales Support
EMAIL: [email protected]
TEL: 1300 922 271
return to its starting position.
If this fails to happen, try turning the ring (a) by hand into its
starting position.
Pull on the blade (4) to check whether it sits tightly in the
blade holder (6).
7.6. OPERATION
7.6.1 ON/OFF switch (Fig.1 /Item 1)
To switch on:
Press the locking button (2) and the ON/OFF switch (1) at the
same time
•
Allow the saw blade (4) to accelerate until it reaches full
speed. Then slowly move the saw blade (4) along the
cutting line. Only exert gentle pressure on the saw blade
as you do so.
To switch off:
Release the locking button (2) and ON/OFF switch (1)
•
If you release the ON/OFF switch (1) the equipment will
shut down automatically which means that it cannot
operate accidentally.
•
Ensure that you do not cover or block the ventilation
openings whilst working with the tool.
•
Do not slow down the saw blade after you switch it off by
pressing it sideways.
•
Important! Do not put down the machine until the saw
blade has reached a complete standstill.
Important. Carry out a trial cut in a piece of waste wood
7.6.2 Use as a jigsaw (Fig. 4)
Place the All purpose saw on the material to be cut as shown
in Fig. 4. Switch on the All purpose saw and push it along
against the material to be cut. Adapt your cutting speed to
the material.
7.7. CLEANING, MAINTENANCE
AND ORDERING OF SPARE
PARTS
Always remove the battery pack before starting any cleaning
work!
7.7.1 Cleaning
•
Keep all safety devices, air vents and the motor housing
free of dirt and dust as far as possible.
•
Wipe the equipment with a clean cloth or blow it with
compressed air at low pressure.
•
We recommend that you clean the device immediately
each time you have finished using it.
•
Clean the equipment regularly with a moist cloth and
some soft soap. Do not use cleaning agents or solvents;
these could attack the plastic parts of the equipment.
Ensure that no water can seep into the device.
7.7.2 Maintenance
There are no parts inside the equipment which require
additional maintenance.
7.7.3 Ordering spare parts
Please contact our After Sales Support on 1300 922 271 and
quote the following data when ordering spare parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Spare part number of the part required
7.8. DISPOSAL AND RECYCLING
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material and can
therefore be reused or can be returned to the raw material
system.
The unit and its accessories are made of various types of
material, such as metal and plastic.
Defective components must be disposed of as special waste.
Ask your local council.
7.9. STORAGE
Store the equipment and accessories out of children’s reach in
a dark and dry place at above freezing temperature. The ideal
storage temperature is between 5 and 30 °C. Store the electric
tool in its original packaging.
