appliance it should be situated in a place where
the atmospheric temperature is between 12 and
32ºC.
-To achieve the highest efficiency from the ap-
pliance and so as to be able to install the appli-
ance on a cold wall (an exterior wall) and below
a window. But never obstructing or covering a
ventilation area.
-The appliance should work well with its wall
support attached or with its base/feet attached.
ASSEMBLING THE WALL BRACKET:
-The appliance has a wall bracket (F) on which it
can be supported.
-Taking into account the separation distances
mentioned above, place the wall support in the
required position and mark the drilling points on
the wall. (Fig.1).
-Drill into the wall where marked and insert the
rawlplugs. (Fig.2).
-Place the support by matching the holes with
the rawlplugs and screw in firmly. (Fig.3).
-Make sure that the bracket is firmly fixed; it
should be able to support twice the weight of the
appliance.
-Fit the appliance into the wall support.
-Take 1 long bracket on the back housing, align
the hole, insert the short screws to fix it (2 short
screws for 1 long bracket) (Fig.4).
-Before Insert the expansion bolts to the wall,
please make sure the distance between bolts as
below table:
Model
Distance
Vilna 600
P
139mm
Vilna 900
P
226mm
Vilna 1200
P
313mm
Vilna 1500
P
400mm
Vilna 2000
P
574mm
-Put 2 long screws to fix the short bracket.
-Fix the short bracket in right position.
-Hang the heater to the bracket (Fig.5).
-Fix the last hole on long bracket after hanging
on the wall (Fig.6).
FITTING THE BASE FEET:
-To assemble the base feet, place the appliance
face down.
-Loosen the screws provided with the appliance
(Fig.4).
-Take 1 stand fixing bracket to align the holes in
the bottom (Fig.8).
-Fix the feet using the brackets provided. (Fig.9).
-Fix the feet with 3 screws (Fig.10).
-Position the base feet on the body of the
-Stand the appliance up again so as to check
that the base feet work properly.
INSTRUCTIONS FOR USE
BEFORE USE:
-Make sure that all products’ packaging has
been removed.
-Prepare the appliance according to the function
you wish to use:
USE:
-Unroll the cable completely before plugging it in.
-Connect the appliance to the mains.
-Turn the appliance on, by using the on/off switch
(A).
-Once connected to electricity, the clock will
pop out on the display for setting. Press
to
toggle among hours / minutes / day. Press the
to set the hours / minutes / day.
-After 10 seconds it will automatically finish and
the appliance will enter to standby mode as
defaulted.
-Press standby button (5) to enter to the comfort
mode.
-In case of power failure, after reconnecting the
power supply, set the time again and the unit
will be in standby mode. You can press the
standby button (5) to enter to the mode and
temperature before power failure.
WORKING MODE SETTING
-Press the mode button (3) to toggle among the
modes: Economic mode
, Anti-freeze mode
, Comfort mode , P1/P2/P3.
-Under the mode of comfort mode or economic
mode (excluding anti-freezing mode), press
or
to choose the desired temperature. After
5 seconds it will automatically finish.
-When the room temperature is higher than
the selected temperature, the heater will stop
heating.
- Comfort mode (setting the desired tempera-
ture from 5ºC to 29ºC).
-
Economic mode (setting the desired tem-
perature from 1,5ºC to 25,5ºC).
-
Anti-freeze mode (the device mantains the
