TAU STERIL s.n.c
Via Gorizia, 6/a
Fino Mornasco ( CO )
Instructions for Use
TAU CLAVE 3000 Fractionated Vacuum
Data: 30.03.15
Pag. 7 di 14
Rev. 3
N° 1
7
This document may not be reproduced in partial form without the authorization of TAU STERIL.
5 Terms of Use
5.1 General information
The controls and displays are shown in the drawing on page. 10 they are:
Control buttons:
1
SELECT
to select the program of sterilization
2
START / STOP
to start / stop the sterilization cycle
3
TEMPERATURE DECREASE
to decrease the temperature of the sterilization program Special.
4
TEMPERATURE INCREASE
to increase the temperature of sterilization in the program Special.
5
DECREASE TIME
to decrease the time in the program Special.
6
INCREASE TIME
to increase the time in the program Special.
5.2 Views
1
PRESSURE
It indicates the pressure in bar.
2
TEMPERATURE
Shows the temperature of steam in the chamber, or by pressing the
right button (+ TEMP) shows the temperature of the heating element.
Also pressing the left button (-TEMP), you can see the selected
temperature cycle.
3
TIME
Indicating the sterilization time of the selected program. They also
bear the identification codes alarms, in addition to writing "FILL"
indicates that the entry of water into the sterilization chamber.
. LED Operation (green)
They indicate the progress of the program:
-
LED off: being not yet executed
-
Flashing LED: phase running
- LED on steady: phase completed
They are: READY = drying
FILL = filling (dose water)
VACUUM = vacuum
HEATING = heater
STERILIZE = sterilization
DRY = drying
END = end of the cycle
PRINT = print
