31
GNALCR - Rev. 04 - Mar/23
•
Check the correct side of the bearings and spacer spools according to the disc
blades concavity.
WARNING
5. Assembly
Disc gangs assembly
1. Place the outer lock (A) along with the axle (B).
2. Place a disc blade (C), bearings (D), shims (E) and spacer spools (F), following the
instructions on the previous pages.
3. Place the inner lock (G) and nut (H) until it passes 5 mm from the axle face.
4. Place the bolt (I) along with spring washer and nut (only on one side of the gangs).
5. Use the wrenches from the 'set of wrenches' page and tighten the gangs as follows:
a) Place one of the wrenches on the inner side of the gangs (locked side) and support
it on the soil (as shown on the next page).
b) Use the other wrench on the outer side and tighten the gangs until it reaches the
maximum torque.
c) To tight the gangs, keep them underpinned using a wood or similar object (as shown
on the next page).
DM bearing
DM bearing
Plug
Plug
