19
Marchesan Implementos e Máquinas Agrícolas “TATU” S.A.
GAPCR / GASPCR
Assembly
First of all, put the parts in a clean place to identify them easier. Check the parts using
the list that comes inside the packing box.
Using the set of wrenches
NOTE We recommend wearing gloves, especially while assembling the disc gangs.
Use two box end wrenches (A) to tighten the nuts of the disc gang, being one to hold
the axle nut on one side while the other tighten the nut to the other end, thereby preventing
the axle from rotating.
The box end wrench (B) is used to tighten the nuts that hold the bolts on the bearings
from the GAPCR model (10 - 16 disc blades); the same wrench (B) is used to tighten the
nuts on the wheelset posts from GAPCR (18 - 30 disc blades) and GASPCR (10 - 22 disc
blades) models.
The box end wrench (C) is used to tighten the bearings and frame from GAPCR (18
- 30 disc blades) and GASPCR (10 - 22 disc blades) models.
The box end wrench (D) is used to tighten the bolts on the drawbar from GAPCR (18
- 30 disc blades) and GASPCR (10 - 22 disc blades) models.
A
A
D
D
B
B
C
C
