9
12. Avoid sharp bends in the connecting pipes ensuring inlet pipe and reject
water pipe has free water flow path.
13. Avoid direct exposure to sunlight or humidity and ensure sufficient
ventilation
14. Ensure waste/reject water pipe is connected to a drain point and water from
reject water pipe is never consumed.
PLEASE ENSURE THAT YOUR TATA SWACH ULTIMA SILVER RO IS INSTALLED
BY A TATA SWACH TECHNICIAN ONLY
Pre-Installation Requisites:
1. 220V single phase AC connection not more than 2m away from the point of
installation of purifier. The wire length supplied with the system is 2m
2. Raw water supply with ½” nipple not more than 3m away
3. Drain for rejected water not more than 3m away
4. Space on the wall as per dimensions of the purifier
5. Wall/plane surface for mounting two screws and holding the machine.
Installation Instructions
1. Turn-off the main water supply before accessing the nipple for connecting
the ball valve and adaptor.
2. Connect the adaptor to the nipple and thread in the ball valve to the
adaptor. Make sure Teflon tape is applied to arrest any leakages from the
threads. Connect the ball-valve with the pipe provided.
3. Remove the front cover of the purifier by pushing the snap button on top.
Take out both the GAC cartridges one-by-one and use the pipe attached to
the ball-valve to flush for 30 sec with water. After flushing, connect it back in
to the system.
4. Connect the pipe to the inlet marked on the purifier. In case you choose to
install additional pre-filter (available at an additional cost), connect the pipe
to inlet of this pre-filter and connect the outlet of pre-filter to inlet of the
purifier.
11
INSTALLATION INSTRUCTIONS
